Withdrawn
Rubber cap for club hammer GRIPLINE hole size 42 x 42 mm
GRIPLINE rubber cap for club hammer with hole size 42 x 42 mm, suitable for a stoning hammer or club hammer.
A rubber cap for club hammer must fit tightly on the hammer head so that it does not become crooked, fall off, or break during work. The hole size of a rubber cap for club hammer must therefore be just slightly smaller than the head size of a stoning hammer or club hammer. After attachment, the rubber cap for club hammer will bulge very slightly.
On the other hand, a rubber cap for club hammer must not be too small. A rubber cap for club hammer that is too small will break during use.
Measure the square head size of your stoning hammer or club hammer in millimeters and check on our website which rubber cap for club hammer is suitable for you. Or take the stoning hammer or club hammer to one of our dealers and choose the best-fitting size there.
This article has been withdrawn and is no longer supplied. It has been replaced by Rubber cap for club hammer ATLAS hole size 42 x 42 mm, for club hammer - stoning hammer (art. 998858).