Withdrawn
Rubber cap for club hammer GRIPLINE hole size 36 x 36 mm
GRIPLINE rubber cap for club hammer with hole size 36 x 36 mm, suitable for a stoning hammer or club hammer.
A rubber cap for club hammer must fit tightly on the hammer head, so that it does not become crooked, fall off, or break during work. The hole size of a rubber cap for club hammer should therefore be just slightly smaller than the head size of a stoning hammer or club hammer. After attachment, the rubber cap for club hammer will bulge very slightly.
On the other hand, a rubber cap for club hammer must not be too small. A rubber cap for club hammer that is too small will break during use.
Measure the head size of your stoning hammer or club hammer square in millimeters and check on our website which rubber cap for club hammer is suitable for you. Or take the stoning hammer or club hammer to one of our dealers and choose the best-fitting size there.
This article has been withdrawn and is no longer supplied. It has been replaced by Rubber cap for club hammer ATLAS hole size 36 x 36 mm, for club hammer - stoning hammer (art. 998842).